Amish Rughoonundon

Amish Rughoonundon

Joined: 11/28/2023

  • RE: Remote Communication to MSO56 for SETUP HOLD trigger

    Tue, 28 Nov 2023 02:06:16 GMT – Remote Communication to MSO56 for SETUP HOLD trigger
    Actually just figured it out. Posting for the next person
    TRIGger:A:LEVel:CH1 1.0 works

  • Remote Communication to MSO56 for SETUP HOLD trigger

    Tue, 28 Nov 2023 01:41:14 GMT – Remote Communication to MSO56 for SETUP HOLD trigger
    Hi,
     I am trying to setup the SETUP & HOLD trigger on the scope MSO56 remotely
    I am able to set most of the options for that trigger except for clock Level and Data Source Threshold
    I cannot figure out what command to send to change those values
    TRIGger:A:SETHOLD:CLOCK:THRESHOLD 1.0
    TRIGger:A:SETHOLD:DATA:THRESHOLD 1.0
    TRIGger:A:Upperthreshold:CH1 1.0
    TRIGger:A:Lowerthreshold:CH1 1.0

    but it does not work. I looked at the Programmer manual but there is nothing specific for these values for the SETHOLD so i am a little confused how to set those

    I also tried the TYPE EDGE trigger and although I can change from a non edge trigger to edge trigger and again I unable to set the voltage level programatically.

    Any help would be highly appreciated
    Amish