Bishal Dumre

I was able to find trigger flow in Trigger -> Configure. However, it introduces delay in each successive measurement rather than between forward and reverse sweeps. Also, how can we go back and put the correct code. What is the exact keyword to put such kind of delay?

Thank you very much in advance for helping me.

Keithley 2460 SMU.

Hello,

The <dual> parameter in "SOUR:SWE:VOLT:LIN" allows to forward sweep and immediately reverse sweep.

We can put delay time between two successive measurement points by using <delay> parameter, but not between sweep directions.

However, I wanted to put some delay between forward and reverse sweeps.

How can we do it?

Please help me.

- Bishal