You’re offline. This is a read only version of the page.
Skip to main content
Tektronix, Inc.
Toggle navigation
Products
Solutions
Calibration & Services
Support
Support
TekTalk
All
All
Forums
Search Filter
Forums
Enter your search term. Use asterisk (*) as a wildcard character.
English
English
Việt Nam
русский
中文(台灣)
中文(中国)
日本語
한국어
français
Deutsch
Login
Home
TekTalk
Oscilloscopes
DPO72304DX Not Saving Y Data
DPO72304DX Not Saving Y Data
Posted
Tue, 20 Feb 2024 17:41:35 GMT
by
Rice, Billy
As the title suggests my scope is not saving the y values of my waveforms. In the .csv output files each Y value is replaced by "#N/A". I've had this scope dump my data before when I ask too much of it processors. The weird thing is the data is still displayed on the screen. Not only that but maths can be performed on the time-domain data including FT to frequency domain. So the data is stored somewhere, it's not writing in to the files though.
I am using FastFrame set up. In the image the top window is a previously saved file while the bottom is the current problem. No changes were made to the setup between the two. The only difference is about two weeks had passed where it was unused. I guess my ultimate question is what the third number in each line of the output files represents and why is it missing from my files?
Posted
Tue, 20 Feb 2024 23:37:33 GMT
by
Teles, Afonso
Hi Billy,
1) That third number represents your y value.
2) I am not sure why it's missing from one of your files, would you be able to share a picture of TekScope when you try to save a waveform which leads to this issue?
You must be signed in to post in this forum.