Ivo Vinklárek

Hello,

I am trying to use python for data logging from our MDO34 scope. Is there a way how to read out trigger status?
I was trying 'TRIGger:STATE', which replies me "Triggered" all the time. However, I would need readout the data (voltage on one of the channels) just once after the trigger (10-100Hz). Therefore, I get data from the scope more often then I should for 10~Hz measurement.

Is there a way how to 1) check the status of trigger and 2) if triggered  3) do a function and then repeat after another trigger?

BW,