-
RE: How to Change Measurement default soruces with command before add measurement?
Hi Iris
Thank you very much
I found this command "MEASUrement:ADDMEAS DELAY" can change measurement type
but can't presetting source1、source2 -
How to Change Measurement default soruces with command before add measurement?
Hi everyone
I am using Tek MSO54 and FW version is 2.0.3.950
I know use command can create measurement, ex. MEASUREMENT:MEAS10 -> is create MEAS10
but I want setting Measurement source(not use default source) before ADD Measurement
I can't found any command example can setting source before create measurement in 4-5-6-Series-MSO-Programmer Manual
I want know how to use command change Measurement type and setting source in this screen(File MSO2.jpg)
Best Regards
Louis
You’re offline. This is a read only version of the page.
