Forum User

I have MSO64, 2.5GHz, 4channel 25 GS/s. When I turn it ON, it shows the following message: "The Oscilloscope was unable to completely restore the state, although as many settings as possible have been restored. Possible reasons included * A probe or other accessory has been attached or removed * An option license has expired" In few seconds, it turns OFF by itself.

What software is recommended for the FCA3120 ? It appears that the SIGEXPTE is no longer available.

I am looking for high current AC/DC hall effect probes that are compatible with oscilloscopes. Our required current is 2000 to 5000 A. However, I could not find any AC/DC probes which is fit to our requirement. I will appreciate it if you could prove me with more information about those.

Channel A has a +22.3uA offset in open circuit. Channel B has a <0.1pA reading in open circuit. Sources are set to zero. The channel A offset persists when connected to a 6220 precision current source while Channel B reads the same as the current source. I tried a factory reset, but that didn't change anything.

I'm having problems with Channel A supplying more current than I am requesting on my 2602. For example, I have a 1k resistor between pins one and four in the back of the unit and has it supplying 0.1 mA, but the results are showing 0.937 mA. I have tested this on Channel B with no problems, along with my other 2602's (B versions), which have no problems on either channel. Do you know what could be causing this problem?
Thanks

I need help with changing the output voltages on my 5054. I was using the device to transmit a 2 V (TTL) auxiliary output to a camera, and am now trying to change that value to 5 V. I can't seem to figure out where to go.

Does the 2230-30-1 came with a certificate of calibration when purchased, and if not, how would I go about receiving this information?
Thanks

We were looking to purchase some Pelican cases for frequently shipped pieces of equipment. Do you folks by chance sell Pelican cases that fit your DSA8300 unit? If so, would you be able to provide us with a quote and lead time for a QTY of 2?

If not, could you point us in the direction of where to purchase these? Thank you very much!

After upgrading his TBS1064 to the TBS2000B, I am having trouble while capturing. When capturing a trigger on the newer unit, I set the trigger to 500 ms for each square. When I did this on the TBS1064, the unit would only save about 6 seconds, which was the size of the screen. Now, on the 2000B, he says it saves minutes' worth of data, which he claims is far too much.

Can I change this?

Is it possible to export measurements from my TPS2014? I see on the menu that there is an option to save a screenshot, but I would prefer a 'CSV'-type file with the actual numerical measurements that I could then view on a spreadsheet. I am currently capturing Voltage and Current measurements (Point to Point), both being on separate channels. Can you help?