Nicholas Wilhelm

Hi Abraham,

I have emailed the requested CAD files to you. The 3 Series files are large so let me know if you do not receive them.

Hello! I have sent the 3D CAD files for the AWG7122C to your email. The C version files are essentially the same as the B version. Let me know if you do not receive them.

Hi RaeShelle,

If you received OEM Calibration Services for you two DESCO ESD Mats, we recommend you reach out to your local Tektronix Service Center using the following link:
tek.com/services/calibration-services/locations

Our service centers may have access to your calibration certificates. 

Thank you!
Nick
Tektronix Technical Documentation

Hello,

I took a look through our documentation archive and could not find an instruction manual for the Tektronix Quick Start 3 Board. I could only find instructions for the Quick Start 8 board.

I am going to move this question to the Vintage and Retired Models forum to see if that community is able to help you out.

Nick Wilhelm

Tektronix Documentation

Thank you for reaching out! You are correct, the current PULSEWidth:WHEn argument for greater than is not valid. I have updated the manual to change the argument value from "than" to "MOREthan" (see attached PDF). This updated PDF will be on tek.com later today. 

Nick Wilhelm
Customer Documentation

Hello,

Attached is the only document I could find for the Training Board 3 Kit. I hope it helps.

Nick
Tektronix Customer Documentation

Hello!

I am checking our archives to see if I can find a PDF of the instruction manual for this Training Board kit. I will let you know what I find early next week. 

Nick
Tektronix Customer Documentation

Hi Doug,
The 1720 Series Vectorscope is now owned by Telestream. We have found a 1988 version of the user manual with schematics included (pages attached). You can find the full version of that manual by searching for 070-5846-00. For more information regarding the 1720 Series Vectorscope please reach out to Telestream.