Diane Otília Lima Fontes

Hi, everyone! I'm new here and hope you can give me a hand.
 

I am using the AFG1062 and would like to configure it using Python. Specifically, I want to operate it in burst mode with the internal trigger.

In the AFG1000 Quick Start User Manual, it is described how to manually set the trigger interval parameter. However, I could not find information in the AFG1000 Programmer Manual about how to perform this configuration via code (or perhaps I may have missed it).

Could you confirm if there is a command available to modify the trigger?

Thank you in advance for your attention, and I look forward to your response.

Best regards,
Diane Fontes