Jordan Clarke

Thank you both for the fast reply.
The firmware is up-to-date.
This was my fault,user error.
I did not see the start enable timer button!

Thank you for helping out with this

Hi,
I have setup a simple situation where the DMM triggers from an external source, waits with a timer for lets say 1 second,  then takes 10 measurements (loops) until done.
This works as intended until I try and change that timer value.
I've made a short video to show whats going on, Easier than trying to explain it.
This could be user error but I have a feeling its a bug.
https://www.youtube.com/watch?v=g9NauzUXyR0
Kind regards
Jordan