Kieron Higgs

I think it depends on what firmware version you have installed if you select Help on the menu and then about the dialog box will tell you what version that you have 

If you had installed the previous version (Version 2.10.5.1825 the one with the TDR measurement) i think you should be ok 
but that is how I have understood the known bugs.

I will be installing it this weekend as I am away from my scope right now (I have Version 2.10.5.1825 installed)


Hope that helps

Hi Ive just had a look at your jpg unfortunately it appears that you misread the screen you have two channels open
Channel 3 and Channel 4 channel 3 is set for 100mV per division and channel 4 is set for 1V per div

The display is set to overlay mode

Channel 4 is active so that is why the graticule is set at 1v per div.

to prevent this confusion from happening again set the screen to stacked mode 
To do this double tap on the screen area to get the waveform view dialog box and tap Stacked  in display mode this will set up each graticule 
for the voltage that you have set for each channel. You could of course just hit the channel 3 button on the front panel to make channel 3 active.

Hope that helps