Posted Thu, 13 Oct 2022 20:07:37 GMT by Fratian, George
I am trying to measure a very fast signal and was wondering how to configure the 2182A to continuously output voltage measurements (and what the limits are in measurements/sec) Sending the :measure? or :read? command is too slow. Ideally, I'd like to get measurements at greater than 100hz rate. Any help would be greatly appreciated, especially SCPI remote commands to enable this measurement mode.

Posted Thu, 13 Oct 2022 20:20:17 GMT by McKinney, Ty
I'll attach a snippet from the 2182A data sheet and post the link to download the datasheet as well as the reference manual below.
The reference manual will have all of the SCPI and operational information you would need for your application.


Reference Manual:
Models 2182A Nanovoltmeter User‚s Manual | Tektronix
See section 13 for SCPI command reference. Also, to manipulate speed I would alter your NPLC, delays, filters, etc. to fit your specific needs.

You must be signed in to post in this forum.