Remote Communication to MSO56 for SETUP HOLD trigger

Hi,
 I am trying to setup the SETUP & HOLD trigger on the scope MSO56 remotely
I am able to set most of the options for that trigger except for clock Level and Data Source Threshold
I cannot figure out what command to send to change those values
TRIGger:A:SETHOLD:CLOCK:THRESHOLD 1.0
TRIGger:A:SETHOLD:DATA:THRESHOLD 1.0
TRIGger:A:Upperthreshold:CH1 1.0
TRIGger:A:Lowerthreshold:CH1 1.0

but it does not work. I looked at the Programmer manual but there is nothing specific for these values for the SETHOLD so i am a little confused how to set those

I also tried the TYPE EDGE trigger and although I can change from a non edge trigger to edge trigger and again I unable to set the voltage level programatically.

Any help would be highly appreciated
Amish

Actually just figured it out. Posting for the next person
TRIGger:A:LEVel:CH1 1.0 works