Forum User

• Does the Tek MSO 4 or 5 have segmented memory?
• Does the MSO 4 support an external TRIG input?
• What is the update rate (spectrum analysis option) of the MSO4?
• For the Tek scope upgrades, I found "SUP4-SV-RFVT" which lists RF versus time analysis and trigger.
o What does this mean? Does the scope trigger on the frequency domain?
o Is this triggering on a specific frequency and amplitude? How narrowly can this be set? I'm picturing a windowed trigger in the frequency domain.
o Does this have a really slow refresh rate (waveforms/s)?
• The MSO 4 upgrades page says that to get SUP4-SV-RFVT, "4-SV-BAS required", but I couldn't find that option in the list. What is that?
• What's the base bandwidth of the Tek MSO 4 spectrum analysis option? I only saw mention of upgrading it 500MHz, but not what the base bandwidth is. I take it this is completely separate to the bandwidth of the scope frontend?

I am looking for the digital copy of the TDS 071-0630-02 technical manual (for scopes like TDS500-600-700). I do have a physical copy but wanted to see if there was a digital version.

Hello,

I am looking for TDS7404B SM (Serial Masking) license.

Thank you

Can you suggest replacement parts similar to
TDS3032C w/ Rackmount and TDS3GV.

Thank you!

I am looking to view current using TCP202 current probe. I would like to record data continuously. I have a DPO4104 scope as well, so the TCP202 will connect to TPA-BNC adaptor then probe.

Is it possible to record continuously using DPO4104 or to T-Off one of the adaptors, so we can capture using an external Data Acquisition device?

Is the TDS6604 is compatible with the TCA-1MEG?

I have download the Keithley_DMM6500_VISA_Driver.py and a modified version of the Keithley_DAQ6510_Example_01.py, but unfortunately when I run it, it gives me a timeout error.

I am using Python 3.9.4 in a Windows 10 system CMD window to talk to a DAQ6510 over USB. Why is it timing out on me?

I see the clear instructions for placing the generator in the sweep mode, on setting the start and stop frequencies. My question is where does the sweeping ramp voltage come out to provide control of the horizontal sweep of a scope to demonstrate the swept response of some device under test?

One of my TDS 210 units is not preconfigured for GPIB and I am wondering if I can take a board from one TDS 210 and swap it to the other 210?

I have been having trouble with this scope for a while. It started out with loading up to the normal screen after boot up but the hourglass would stay on the screen and never actually allow me to use it. I let it sit for a while unplugged from power completely and now it wont load past the start up/ splash screen. If tried power cycles using the power button and unplugging it completely. Any idea what the issue may be?