Tektronix Applications Expert

These three probes are compatible with the 3 series MDO. The TDP1500 does have a higher bandwidth than our 3 series, but this will not affect the compatibility up to the scope bandwidth limit.

I recommend using a 50 ohm resistive power splitter/combiner like the Mini-Circuits ZFRSC-2050+ (https://www.minicircuits.com/WebStore/dashboard.html?model=ZFRSC-2050%2B). Using a BNC-tee won’t damage your AFG but you might not get the amplitude you expect due to double loading. What amplitude (and frequency) are you looking for and is this something you need often?

Yes, you can get information to a computer without SignalExpress by writing some software. Please see the programmers manual below for examples and commands to control the FCA3000.

https://www.tek.com/en/frequency-counter/mca3000-manual/fca3000-and-fca3100-series-mca3000-series

You can remotely view the screen and change settings with e*Scope. To use e*Scope, connect your scope to ethernet and then enter the IP address into your browser address bar. You will need to make sure that your computer and your scope are on the same network.

Need DPO2CONN for ethernet

See the link below for the 2110 Service manual with the PV and adjust information. https://www.tek.com/en/manual/digital-multimeter/broad-purpose-digital-multimeters-manual-3-keithley-2110-series-5-digit-dual-display-usb-multimeter

Primary Manual can also be found here:
https://www.tek.com/en/manual/digital-multimeter/broad-purpose-digital-multimeters-manual-3-keithley-2110-series-5-digit-dual-display-usb-multimeter

Other links related to the 2110:
https://www.tek.com/en/search?keywords=2110&facets=_templatename%3dManual&sort=desc

The TDS1000 required an option communications module to communicate to a PC. All of these modules are no longer available for sale. If you have a module for the scope please reference the programmers manual for additional details.

Modules:
TDS2CM or TDS2CMA, any version, when used in TDS1000 or TDS2000 Series instruments, any version.

TDS2MEM any version, when used in most TDS1000 or TDS2000 Series instruments (except TDS1001 and TDS2004 models), any version.

SDLC is suppoted on MSO4, MSO5B, MSO6B, not supported on MDO4000

You can find the user manual here: https://www.tek.com/en/oscilloscope/tds1001b-manual/tds1000b-and-tds2000b-series

The best place is this customer's website: https://w140.com/tekwiki/wiki/453

Another one would be VintageTEK:
https://vintagetek.org/

Serial number location could be right under the 543A-4 on front.
Or lower left by Channel one on the 453A-1.
Sorry, not sure for the Rackmount verison.
Very old scopes liek this were usually on the front.
1980's and up were on the back.

The MSO4000 Series oscilloscope uses the P6516 logic probe, part number 071214901.