-
Instrument to Measure Resistance
What instrument to use when measuring resistance on a circuit that cannot tolerate a lot of measurement voltage or power?
-
ECCN codes for shipping MSO58
What are the ECCN codes for shipping the MSO58 to the USA?
-
Python Support for 2701
Does Tektronix offer Python Drivers for the 2701?
-
Drain-to-Source Voltage Measurement Discrepancies with MSO58 with TIVH05L and THDP0200 probes
Hello, out lab is using the MS058 OScope to measure the drain to source voltage on an LLC converter with a front end PFC circuit. We are seeing some discrepancy in our measurements when using two different probes. I was hoping to get some advice on this topic. The summary of the two probes is below:
- using a TIVH05L IsoVu probe with the SQPIN 500X tip the turn off VDS measurements show the voltage overshoot to be ~500V.
- using a THDP0200 the measurements are showing significantly higher overshoot voltages (~650V).
Any recommendation on which measurements are accurate and what explains the discrepancy between the two measurements?
-
Repair DPO4034B
Who do I contact to repair a DPO4034B?
-
TDS2014C Waveform Screen Capture
How do I change the saved file format of a waveform screen capture on a TDS2014
-
KIckStart 'US Government regulation'
Is there a 'US Government Regulation' hold when downloading KickStart from Tektronix?
-
MSO46 Dotted Line on Display
Can the dotted line on the MSO46's screen, right under the triangle where the trigger position is, can be turned off?
-
Manuals for RTD720
How can I purchase a manual for the RTD720?
-
DMM6500 to trigger an oscilloscope
Hi,
I'm doing a study on including DMM6500s in an automated test equipment application to replace manual test procedures. Our current procedures use a clamp on current probe to trigger a o-scope when a DC inrush current rises above a specific level. I'm trying to see if the DMM6500 can be used in place of this current probe and have the following questions:
- Can you set the digitizing current function on the DMM6500 to trigger on the rising edge of a user-input threshold current?
- Would this waveform trigger generate a signal on the trigger output signal on the rear panel of the DMM6500?
- What's the time delay between the waveform trigger and the rear panel trigger output?
- Can the DMM be configured to perform this function using SCPI commands?
- Can the digitized buffer be read into a workstation using SCPI command?Thank you,
Jeff