Forum User

we have an AWG5014C that currently is password protected and we can't get into it. the username is OEM, but can't find the default password. It is running windows 7

We recently had a power surge that reset the windows password. We can no longer log in to our AWG.

when the students do measurements while using the TDS with the 1 Times TO 10 Times PROBE they are for some reason getting measurements that are off by 10. The Professor thinks they probably are turning it off & on and it is setting the Default to 10. Professor is guessing but, would like assistance on setting it to

I would like more information on removing the main board. Specifically whether or not it is required to sanitize the machine, or if it's only required if the equipment isn't functioning properly.

Declassification/Security documents for TDS3054D

Hi I am looking to run DDR5 software packages and signal Integrity functions on our MSO7804DX Scope. Everything available please

We are seeking a two channel Function Generator capable of producing output less than 50 mVpp when load is Hi-Z mode.

In addition we are going to have to use an external power supply to provide a 25 VDC offset to overcome limitations of the instruments. Can you recommend a function generator that can meet these requirements, and how we could connect the DC supply in series with the function generator output?

For the dBm calculation, what is the impedance assumed? Is this based on channel impedance or some other factor?

Over the past week I have been seeing that my units time has been slowly lagging behind, to the point where today it sits 48 minutes behind the actual time. I tried setting it to EST, then back to PST to refresh it, but unfortunately, it stayed at the same time.

Is there a software package that allows data logging from an MDO34 Oscilloscope? I have downloaded the free trial of the kickstart software but it doesn't seem to be able to data-log for the MDO34