Sam Fisher

Hi Afonso,

Thank you for this clear information. I use Hercules to check if everything works. At the end of the day I will connect Siemens S7-1500 series PLC to DPO4054 and that's why I think I should use "raw sockets". Maybe I should add a PC and use it as a gateway.

Hi all,

I want to send commands from Hercules software to DPO 4054 over ethernet. What is the TCP port number for sending commands? There is a video on this link : How do I configure the LAN settings on an MDO4000C series oscilloscope? | Tektronix. I only see e-Scope HTTP port number. Is it same?

Thank you in advance.