Massimiliano F.

let's follow up via e-mail.
I sent you one on 26/03

Hi,
this is not a behavior caused by FW issues.
One of more hardware parts are defective, but we can't provide a remote diagnosis.
Recommendation if contact Local Support and get ask for a Repair offer.
 

Hi David,

the statistics are calculated over multiple acquisitions. let's say you acquire 1000 waveforms.
so you will see
the average values of the 1000 RMS values 
the stddev based on the 1000 RMS values
the peak RMS value among the 1000 calculated
etc

the RMS value is unique with no statistics if you do a single shot acquisition.

 

Hi Jeff,
you will see the names if you enable the header with the command
"HEADer 1"

the measurement algorithms are described in the Help-Manual, in the section "Measurement algorithms".
4, 5, 6 Series MSO Help | Tektronix
I'll send you an e-mail with details

Hola Jose.
do you want to generate a Multi-tone signal? this is a complex waveform, AFG31k does not have a plug-in or built-in function for this.
but any function (square, triangle etc) has an harmonics content, you can check with an FFT on Scope or a Spectrum Analyzer.

Hola Jose,

no, sorry but mouse is not supported on AFG31000. you can edit inArbBuilder only with touch-screen.

Hi Diane,
not all the functions and parameters of AFG1000 are implemented with SCPI command.
the command is: [SOURce[1|2]]:BURSt:SOURce TIMer
but there is no command to define the trigger interval, which is 1 second by default.

As workaround, you could set the trigger internal value, then save setup and recall it with SCPI (*RCL)

Hola Jose,

there is no direct waveform file format that AFG31000 can load from MSO56.
one way could be save from MSO56 as CSV, import this in ArbExpress on PC and save as TFWX (Advance Mode) or TFW (Basic Mode). the CSV header may need to be edited.
Mind that the number of samples on the AFG31000 is limited to:
- 131k in Basic Mode
- 16M to optional 128 M points in Advance Mode.

if you are located in EMEA, we can follow up via e-mail.

Hi, can you provide the output in the Python console, after launching the script?
specially, what does "print(f'Will send: {send_this}') # Will send: b'WLISt:WAVeform:DATA "deleteme",\x01\x00\x00\x00\x02\x00\x00\x00\x03\x00\x00\x00\n'"
shows?

do you get errors from AWG5000 or from SYST:ERR, or from Python?

are you located in EMEA region?